[关键词]
[摘要]
针对滑模观测器的永磁同步电机参数误差容易造成估算误差和反电动势中存在高频纹波分量的缺点,使用低通滤波器不能有效消除高频纹波,提出在滑模观测器前端引入卡尔曼滤波器来消除高频纹波,使得永磁同步电机的控制系统具有更好的稳态效果和动态响应。依据设计仿真搭建MATLAB平台,对提出新方法进行验证。试验结果表明增加卡尔曼滤波环节后的滑模观测器不仅鲁棒性强,而且在一定程度上有效抑制了抖振,在系统快速性及稳态性能上都有较好的效果。
[Key word]
[Abstract]
Aimed at problems of high frequency ripple component exists permanent magnet synchronous motor (PMSM) parameter error caused by the sliding mode observer estimation error and counter electromotive force. However, a lowpass filter cannot eliminate the high frequency ripple, Therefore, the introduction of the Kalman filter to eliminate highfrequency ripple, making permanent magnet synchronous motor control system had better steady state performance and dynamic response. Then a MATLAB platform was built to validate this method, the experimental results showed that after the increase in the Kalman filter sliding mode observer not only robust, and to some extent inhibited the buffeting, there was some increase in the rapid and dynamic performance.
[中图分类号]
TM 341
[基金项目]
国家自然科学基金资助项目(61374132)